Bracelet Segment for Wrist Watch

Finished Weight of Component : 10g
Density (g/cm3) : 8.00 g/cm3
Tensile Strenght (N/mm2) :
Yield Strength (=0.2% N/mm2) :
Hardness :
Treatment :
Description: This MIM part, is used in Opto-Electonics Packages, and one of the requirements is that the material should have a dilation curve similar to that of the glass used to seal the connection.

The part is moulded from a composition designated as F15 (Ni-Co-Fe); tolerances on the holes is +/- 0.02mm. A critical factor for the customer is that the MIM electronic box is tested to check hermeticity after the part has been subjected to temperature shocks.

The part replaces a similar one made by machining and brazing which as a process was much more expensive than MIM.