Subscribe to the EPMA Mailing List

On 5th March 2020, ISO TC261 has opened the first Committee Draft for ISO-ASTM CD 52931 "Additive manufacturing — Environmental Health and Safety— Standard guideline for use of metallic materials" to ballot.

The draft document is available here (EPMA Members only): pdf ISO ASTM Standard guideline for use of metallic materials (821 KB)

According to ISO procedures, the Committee Draft (CD) is circulated to the members of the committee who then comment and/or vote using the electronic balloting portal. The ballot is conducted among 26 Participating members and followed by 7 Observing members plus 22 liaisons, including EPMA. The deadline for the ballot is 1st May 2020.

Stages for developing ISO standards

The workflow of ISO is described above. If the Committee Draft (CD) gets approved in this ballot and goes onto Enquiry stage, the standard is planned to be published on the first month of 2022.

 If you want to add any comments depending on your experience and contribute to the  balloting process, please use the form below, or contact Kenan Boz (This email address is being protected from spambots. You need JavaScript enabled to view it.).

Send Feedback

If you would like to send feedback on this article, please fill in the form below:

Please enter your name
Please enter a valid email address
Please enter a message
Invalid Input
Go To Top