Introduction to AM: Submit a Case Study

If you would like your AM component to be considered for inclusion in the next version of EPMA's Introduction to Additive Manufacturing Technology brochure, please fill in the form below.

Should you have any specific questions, please contact Andrew Almond, Marketing Manager at aja@epma.com.

Submissions are subject to approval before being published.

Fields marked with * are required

Component Information

Name of Component*

Please enter the name of the component

Material
Hold CTRL to select more than one*

Please select what material(s) the component is made from

Please specify*

Please specify what material(s) the component is made from

End Use Sector
Hold CTRL to select more than one*

Please select the end use sector

Please specify*

Please specify the end use sector

Component Details

Please enter any specific relevant information relating to the production process
eg. type of tooling, consolidation pressure, sintering temperature etc.

Give details of any finishing process used
eg. sizing, machining, heat treatment, coating, etc.

Chemical Composition

Invalid Input

Why AM?
Advantages, benefits etc.*

This field is required

Please also include, if possible:

Itemise any special design features which have helped this product to be produced by a AM processing route, as against a competitive metal forming process.
State if the product was designed specifically for AM - if not, which process has it replaced? Particularly important will be details on the technological/economic benefits to the end user of AM products.

Benefits

Cost Saving

Improved Performance

Increased Component Complexity

Weight Saving

Invalid Input

Component Dimensions

For EPMA reference. For more complex parts an approximate measurement will be sufficient.

Length (mm)

Please enter the length of the component in mm

Width (mm)

Please enter the width of the component in mm

Height (mm)

Please enter the height of the component

Component Specification

Please enter relevant properties of finished product (please enter all that apply):

Material Standard

Invalid Input

Weight (kg)
Finished weight*

Please enter the finished weight of the component in kg

Diameter (mm)