
Description
The part is made from 316L stainless steel powder sintered to 7.3 g/cm3 density making it gas tight for burning pressure. Tensile strength of the part is put at 400 MPa, and hardness at 100 HB. There are no additional finishing operations except at the outer diameter.
Benefits
This metal injection moulded part weighs just over 40g and is used as a burner chamber for an independent heating system in cars and trucks. Special design features of this part include the cross hole at under 9«, and the DIN number and other characteristics are produced during moulding.
Component Specification
The information contained in these case studies is provided by third parties and although EPMA does its best to ensure the case studies are accurate it is not liable for any mistakes or wrong information