Double Bulge Diamond Bead for Stone Cutting
Requirements
The fabrication of the beads for diamond wires for stone cutting is commonly performed by means of hot pressing, both uniaxially and isostatically, but more and more often by means of the press-and-sinter route. In the former processes the densification of the powders is aided by a pressure applied by a graphite ram or by an inert gas; on the contrary, in the press-and-sinter process densification occurs at low pressure (or vacuum) only because of the effect of temperature. In all cases a preforming of the green bead by means of uniaxial cold pressing is required.
Benefits
A totally new patented system based on Metal Injection Moulding (MIM) technology has been developed and offers considerable advantages in speed and cost saving.
Component Specification
The information contained in these case studies is provided by third parties and although EPMA does its best to ensure the case studies are accurate it is not liable for any mistakes or wrong information