Subscribe to the EPMA Mailing List

Rocker Arms

  • Share this page:
Rocker Arms
Benefit: Cost Saving, Increased Component Complexity
Main Forming Process: Conventional Processing
End Use Sector: Automotive
Material: Ferrous


The body of the arm shown is made from a low alloy steel powder to which is sinter bonded a highly wear resistant Mo-alloyed PM steel tip. PM rocker arms can replace conventional forged and cast rocker arms through the ability of PM to produce composite parts having tailor-made properties where required.

The information contained in these case studies is provided by third parties and although EPMA does its best to ensure the case studies are accurate it is not liable for any mistakes or wrong information

Go To Top